Dexon Canada Ventilation Equipment
MDVA SERIES Vent Fan
- Outdoor Flange Mount -

Print this page

MDV SERIES VENT FANCONTROL PRINCIPALS:

AC fan will run continuous at full speed

PLEASE BE AWARE: When using the MDVA Series 120 VAC, NON IDLING VENT FAN - under certain climatic conditions, the potential exists for freezing and ice build-up in the discharge pipe of the ventilation system of a pump station. The amount of ice build-up may be sufficient to prevent the proper ventilation of the station.  For this reason we highly recommend the use of Vent Fans with variable speed blowers, running at a continuous idle speed, where climatic conditions do not necessitate the use of blower heater. The use of vent fans blowing continuous unheated air at FULL SPEED is not recommended in cold climate areas, and their use will be at the sole risk and responsibility of the owner.

 

ELECTRICAL REQUIREMENTS:

  • 120 Volt, 60 Hz input power
  • 46 - 90 watts Maximum

MECHANICAL REQUIREMENTS:

  • Typical discharge is a 6 inch diameter flat bottom with gasket supplied
  • Pipe adapter or flanged down pipe supplied by others
  • Dimensions 750mmH x 300mmSQ
Site by B Smith Media
Copyright © 2011 Dexon Canada Air Systems Inc.